Using The Reset Button; Uploading A Configuration File Via Console Port; Figure 2-4 Example Xmodem Upload - ZyXEL Communications Prestige 792H User Manual

of 9600bps with 8 data bit, no parity, one stop bit and flow control set to none. The password will be reset
to "1234", also.

2.5.1 Using The Reset Button

Step 1. Make sure the SYS LED is on (not blinking).
Step 2. Press the RESET button for five seconds, and then release it. When the SYS LED begins to
blink, the defaults have been restored and the Prestige restarts.

2.5.2 Uploading a Configuration File Via Console Port

Step 1. Download the default configuration file from the ZyXEL FTP site, unzip it and save it in a
folder.
Step 3. Turn off the Prestige, begin a terminal emulation software session and turn on the Prestige
again. When you see the message "Press Any key to enter Debug Mode within 3 seconds", press
any key to enter debug mode.
Step 4.
Enter "atlc" after "Enter Debug Mode" message.
Step 5. Wait for "Starting XMODEM upload" message before activating Xmodem upload on your
terminal. This is an example Xmodem configuration upload using HyperTerminal.
Step 6. Click Transfer, then Send File to display the following screen.
Step 7. After successful firmware upload, enter "atgo" to restart the router.
Introducing the Web Configurator

Figure 2-4 Example Xmodem Upload

Prestige 792H User's Guide
Type the configuration file's
location, or click Browse to
search for it.
Choose the Xmodem
protocol.
Then click Send.
2-5