Procedure To Use The Reset Button; Uploading A Configuration File Via Console Port; Figure 6 Example Xmodem Upload - ZyXEL Communications ZyWall 70 User Manual

2.3.1 Procedure To Use The Reset Button

Make sure the SYS LED is on (not blinking) before you begin this procedure.
1 Press the RESET button for ten seconds, and then release it. If the SYS LED begins to
blink, the defaults have been restored and the ZyWALL restarts. Otherwise, go to step 2.
2 Turn the ZyWALL off.
3 While pressing the RESET button, turn the ZyWALL on.
4 Continue to hold the RESET button. The SYS LED will begin to blink and flicker very
quickly after about 20 seconds. This indicates that the defaults have been restored and the
ZyWALL is now restarting.
5 Release the RESET button and wait for the ZyWALL to finish restarting.

2.3.2 Uploading a Configuration File Via Console Port

1 Download the default configuration file from the ZyXEL FTP site, unzip it and save it in
a folder.
2 Turn off the ZyWALL, begin a terminal emulation software session and turn on the
ZyWALL again. When you see the message "Press Any key to enter Debug Mode within
3 seconds", press any key to enter debug mode.
3 Enter "y" at the prompt below to go into debug mode.
4 Enter "atlc" after "Enter Debug Mode" message.
5 Wait for "Starting XMODEM upload" message before activating Xmodem upload on
your terminal. This is an example Xmodem configuration upload using HyperTerminal.

Figure 6 Example Xmodem Upload

Type the configuration file's location, or click Browse to search for it.
Choose the Xmodem protocol.
Then click Send.
6 After successful firmware upload, enter "atgo" to restart the router.
Chapter 2 Introducing the Web Configurator
ZyWALL 70 User's Guide
61