Figure 337 Menu 11.1.4: Remote Node Filter (Pppoe Or Pptp Encapsulation); Figure 338 Menu 11.1.5: Traffic Redirect Setup; Table 194 Menu 11.1.5: Traffic Redirect Setup - ZyXEL Communications ZyWALL 2 Plus User Manual

Figure 337 Menu 11.1.4: Remote Node Filter (PPPoE or PPTP Encapsulation)

34.6 Traffic Redirect
Configure parameters that determine when the ZyWALL will forward WAN traffic to the
backup gateway using Menu 11.1.5 - Traffic Redirect Setup.

Figure 338 Menu 11.1.5: Traffic Redirect Setup

Active= Yes
Configuration:
Press ENTER to Confirm or ESC to Cancel:
The following table describes the fields in this menu.

Table 194 Menu 11.1.5: Traffic Redirect Setup

FIELD
Active
Configuration
Backup Gateway IP
Address
Metric
ZyWALL 2 Plus User's Guide
Menu 11.1.4 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Menu 11.1.5 - Traffic Redirect Setup
Backup Gateway IP Address= 0.0.0.0
Metric= 14
Check WAN IP Address= 0.0.0.0
Fail Tolerance= 10
Period(sec)= 300
Timeout(sec)= 8
DESCRIPTION
Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic
redirect setup. The default is No.
Enter the IP address of your backup gateway in dotted decimal notation.
The ZyWALL automatically forwards traffic to this IP address if the ZyWALL's
Internet connection terminates.
This field sets this route's priority among the routes the ZyWALL uses.
Enter a number from 1 to 15 to set this route's priority among the ZyWALL's
routes (see Section 8.2 on page
priority the route has.
Chapter 34 Remote Node Setup
151) The smaller the number, the higher
517