To upload System firmware:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
4. After successful firmware upload, enter "atgo" to restart the
Warning: Proceeding with the upload will erase the current router
firmware.
Step 2.
After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on your
computer. Follow the procedure as shown previously for the HyperTerminal program. The
procedure for other serial communications programs should be similar.
21.4.9 Example Xmodem Firmware Upload Using HyperTerminal
Click Transfer, then Send File to display the following screen.
After the firmware upload process has completed, the ZyWALL will automatically restart.
Firmware and Configuration File Maintenance
Menu 24.7.1 - System Maintenance - Upload System Firmware
Xmodem upload on your terminal.
router.
Do You Wish To Proceed:(Y/N)
Figure 21-16 Menu 24.7.1 Using the Console Port
Figure 21-17 Example Xmodem Upload
ZyWALL 10/10 II/50 Internet Security Gateway
Type the firmware file's location, or
click Browse to look for it.
Choose the Xmodem protocol.
Then click Send.
21-15