Ip Static Route; Figure 227 Advanced > Static Route > Ip Static Route; Table 100 Advanced > Static Route > Ip Static Route - ZyXEL Communications ZyWALL 2 Plus User Manual

Chapter 18 Static Route

18.2 IP Static Route

Click ADVANCED > STATIC ROUTE to open the IP Static Route screen (some of the
screen's blank rows are not shown).
The first static route entry is for the default WAN route. You cannot modify or delete a static
default route.
The default route is disabled after you change the static WAN IP address to a dynamic WAN
IP address.
Figure 227 ADVANCED > STATIC ROUTE > IP Static Route
The following table describes the labels in this screen.
Table 100 ADVANCED > STATIC ROUTE > IP Static Route
LABEL
#
Name
Active
Destination
Gateway
Modify
348
DESCRIPTION
This is the number of an individual static route.
This is the name that describes or identifies this route.
This field shows whether this static route is active (Yes) or not (No).
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the ZyWALL's interface. The gateway helps forward packets to
their destinations.
Click the edit icon to go to the screen where you can set up a static route on the
ZyWALL.
Click the delete icon to remove a static route from the ZyWALL. A window displays
asking you to confirm that you want to delete the route.
ZyWALL 2 Plus User's Guide