Honeywell Galaxy Dimension Series Installer Manual page 71

Galaxy Dimension Installer Manual
Configuring a MAX
NOTE: MAX 3 readers can only be configured into the Galaxy system from engineer mode.
1. Connect the MAX
2. Access engineer mode.
3. Ensure that the Mode is enabled (option 69.1.1 = Access Control.Mode.Enabled).
4. Assign the MAX
Control.MAX.MAX Address:
0 = On-Line: The MAX
sharing system resources and facilities.
1 = Standalone (default): The MAX
monitor the MAX
5. Press the ent key; the Galaxy panel may prompt (depending on model) for the AB line (1 – 4)) that is
to be searched; select the line and press the ent key. The Galaxy searches for the MAX
highest address. New MAX
6. Only if adding a new MAX
OPERATING MODE of MAX
and press the ent key.
When 0 = On-Line mode is selected, the keypad displays the current address of the MAX
range of valid addresses. Enter the new MAX
grams the address of the MAX
status of the reprogramming.
NOTE: It is recommended that when adding a reader, it is addressed as the lowest available number on the
line.
7. When the reprogramming is complete the MAX
keypad display returns to 1 = MAX Address.
8. Exit engineer mode - engineer code + esc: the keypad displays the message 1 MOD. ADDED -
esc=CONTINUE. LED 2 on the MAX
returns to the unset banner.
If this message is not displayed, the MAX
and has not been configured into the system (LED 2 does not switch on).
NOTES:
1. The MAX reader will not operate until engineer mode is exited and the reader is configured into the
3
system.
2. All MAX 3 doors must be closed, otherwise engineer mode cannot be exited.
9. The on-line MAX
Reader into the System
3
to the Galaxy control panel as per the instructions given in Figure 5-1.
3
reader as either On-Line or Stand-Alone using option 69.2.1 = Access
3
3 is fully integrated with the Galaxy system and communicates via the AB line,
3 operates as an entirely independent unit. The Galaxy does not
for alarms, tampers or power failure.
3
readers are addressed as 8 (standalone) by default.
3
3 reader: On locating the MAX
to be assigned: select 0 = On-Line or 1 = Standalone as required
3
. The keypad indicates the old and new MAX
3
reader is not communicating with the control panel
3
3 reader is now configured into the system.
Access Control (cont'd)
3 address, the keypad prompts for the
3 address and press the ent key; the Galaxy then repro
bleeps, the LED's on the MAX
3
reader switches on. Press the esc key; the keypad
3
5-9
3 with the
and the
3
addresses and the
3
switch off and the
3