Honeywell Galaxy Dimension Series Installer Manual page 245

Galaxy Dimension Installer Manual
65.2 = Timer Outputs
Once the times have been programmed and the Status is set to 1=On, the Timer-A or Timer-B outputs
53.29 and 53.30 are activated at the On times and deactivated at the Off times programmed in
65.1=Weekly Schedule. User codes that they have been attributed to a Time Zone A or B are invalid
between an On time and the next Off time for the appropriate timer.
65.3 = Autoset
Each group can be programmed with up to 67 (dependent on panel variant) Autoset times over a 7 day
period. These can be combined in any order of On and Off times as required.
When the system has been set by the Autoset function, outputs programmed as Autoset (refer to option 53 =
PROGRAM OUTPUTS) are activated; the Set outputs are also activated.
Programming Autoset
If groups are enabled (refer to option 63 = OPTIONS) the keypads prompts for the group that the autoset
time is to be allocated to. Press the A or B keys to step through the groups until the required number is dis-
played and press the ent key.
NOTE: The group can be directly selected by entering the group number. Larger Galaxy systems have 32
groups; these are displayed in blocks of eight groups, sub-divided into A, B, C and D;
Use the A or B key to select the required group (A1–D8). When the end of a block is reached, the next
block of eight groups is displayed; use keys 1–8 to assign the relevant group in the current block to the zone;
press the ent key to accept the selection.
Account Group Autosetting
The Galaxy Dimension allows Account Group autosetting. This means that several groups can be bound
together into one account group and, instead of a sending a normal CA event, the panel sends a CL event.
Refer to menu option 56.1.2.2.2 = Communications.Internal Telecoms.Format.SIA.Group
Settings.Account No.
G o r u p B o l c k P h y
A 1 8 -
B 1 8 -
C 1 8 -
D 1 8 -
Table 6-30. Groups
6-171
65 - Timers (cont'd)
s c i l a G o r u p s
1 8 -
9 1 - 6
1 7 2 - 4
2 5 3 - 2