Honeywell Galaxy Dimension Series Installer Manual page 148

52 - Program Zones (cont'd)
8 = Activity Mon.
This attribute allows a zone to be checked for activity during a set time period or set/unset cycles. The options
are:
• 0 = None
• 1 = Type1
• 2 = Type2
• 3 = Type3
• 4 = Type4
• 5 = Type5
• 6 = Type6
The default option is 0 = None.
If the zone does not activate at least once within the programmed criteria a zone masked fault is indicated at
the panel. The fault is logged as a masked event which indicates that the zone has been inactive for the pro-
grammed period. See Option 51.61=Parameters.Activity Monitoring.
9 = Res. Select
This option allows the zone resistor configuration to be selected from a pre-defined value.
• 00 = System (follows the system default as programmed in parameter 51.46 = Zone Resistance)
• Option 01 = Preset 1 - 1k (double balanced)
• Option 02 = Preset 1 - 1k (end-of-line)
• Option 03 = Preset 2 - 2k2 (double balanced)
• Option 04 = Preset 2 - 2k2 (end-of-line)
• Option 05 = Preset 3 - 4k7 (double balanced)
• Option 06 = Preset 3 - 4k7 (end-of-line)
• Option 07 = Preset 4 - 5k6 (double balanced)
• Option 08 = Preset 4 - 5k6 (end-of-line)
• Option 09 = 1k Fault (double balanced)
• Option 10 = 1k Fault (end-of-line)
The values assigned by each of the options are shown in tables 10 and 11, Parameter 51.46=Zone Resist-
ance.
10 = Group
NOTE: The Groups attribute is only available if groups have been enabled on the system (refer to option 63
= OPTIONS).
The Group attribute allows the zone to be assigned to a single group on the system. All zones default to
Group A1.
On selecting the Group attribute, the group that the zone is currently assigned to is displayed. All zones
default to group A1. Press the number of the group that the zone is to be reassigned to and press the ent key.
Multi-group Systems
The larger Galaxy panels have 32 groups; these are displayed on the keypad in blocks of eight groups, sub-
divided into A, B, C and D:
Galaxy Dimension Installer Manual
6-74