Rf Rio Programming; Configuring The Rf Rio - Honeywell Galaxy Dimension Series Installer Manual

Hide thumbs Also See for Galaxy Dimension Series:
Table of Contents

Advertisement

RF RIO (cont'd)
Address Ranges
This option allows the programming of the RIO addresses, which are to be simulated by the RF RIO.
For example, if the RF RIO being programmed supports 32 zones (4 RIO addresses), and the base address,
programmed at the hexi-decimal rotary switch is 02, the available addresses would be 02, 03, 04, 05. How-
ever, you may want to only respond as RIO addresses 02, 04. The remaining addresses should be disabled
and will not respond to commands from the control panel. The base address is enabled by default. All other
addresses are disabled by default.
Module status on the RF RIO such as lid tamper,will be reported to the panel using the address set on the
rotary switch.

RF RIO Programming

Programming of the RF RIO is achieved by connecting a Galaxy Mk7 keypad directly to the RF RIO at the
Programming Keypad Socket or the Keypad Connector Block. The Keypad is not part of the Galaxy net-
work and must be addressed as 0.
Note:
To program RF devices, please refer to RF RIO Module, Installation and Programming
Instructions, (II1-0076) supplied with the RF RIO.

Configuring the RF RIO

The RF RIO is configured into the system in the same way as a standard RIO. Refer to standard RIO instruc-
tions for further details.
Galaxy Dimension Installer Manual
3-6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents