Honeywell Galaxy Dimension Series Installer Manual page 263

Galaxy Dimension Installer Manual
06 = AntiPassBack
This option, when enabled, will prevent more than one use of any particular card at a particular reader
within a given time period.
A forgiveness function is available to clear all or particular antipassback restrictions in force. A manager
code can authorize a forgive function on a particular user in option 42.1 = Codes.User Codes. An engi-
neer code can authorize a forgive function on a particular reader.
1 = Mode
This option has three settings
0 = Off
No antipassback restriction.
1 = Soft
Access is never denied but any violations will be recorded in the event log.
2 = Hard
No access will be granted for a second swipe within the antipassback period, following a valid
swipe.
2 = Timeout (0-60 minutes)
This option specifies the time that the antipassback restriction lasts for. The default is 0 minutes.
3 = Forgive
This option allows the engineer to remove all antipassback restrictions for the selected DCM. Use the
A>B< keys to select the reader address the press enter to forgive.
07 = APB
Not used
08 = Security
This option determines when and how a door can be locked and unlocked for access.
1 = Nightlock
This allows a time schedule to be allocated to determine when access to the door will be blocked. Up
to 67 weekly time schedules can be programmed. Setting the schedule to 00 disables the function.
2 = Unlock Time
This allows a time schedule to be allocated to determine when the door will be unlocked to provide
unrestricted access. Up to 67 weekly time schedules can be programmed. Setting the schedule to 00
disables the function.
3 = Dual mode
This defines if access at a door requires dual authority or not via the assigned keypad. The options are:
0 = Disabled
A card or a Pin is required to gain access.
1 = Card and Card
Two cards are required to gain access.
2 = Card and Pin
A card and a Pin from the same user are required to gain access.
69 - Access Control (cont'd)
6-189