Lennox iComfort E30 Installation And Setup Manual page 4

Alert codes which require manual clearing can only be done under the dealer
control center > notification screen.
Table 1. System and Commissioning LED Indicators
LED
Color
System Status LED
Green
Red
RIGHT LED -
COMMISSIONING
STATUS
LEFT LED -
SYSTEM
Amber
STATUS
Magenta
Cyan
OUTDOOR
DISCHARGE
AIR AIR
SENSOR SENSOR
Commissioning Status LED
Blue
Green
Green
Status Description
A solid green LED indi-
System is cates no system errors
normal are detected. System
operating as designed.
System has critical alert
HVAC Fault which needs installer
attention.
Blinking amber LED
indicates either Wi-Fi is
not connected, no Wi-Fi is
Wi-Fi Error within range, or and Wi-Fi
hardware error. Could
also indicate intermittent
Wi-Fi connection.
Blinking magenta LED
T-Stat Error indicates HD display not
connected.
Blinking cyan LED indi-
Hardware
cates E30 internal com-
Error
munication error.
No mobile device is
System is
directly connected using
normal
Wi-Fi to the smart hub.
Blinking green LED indicates the com-
missioning button has been activated and
the smart hub is waiting for a connection
with a mobile device.
A solid green LED indicates a mobile
device is connected to the smart hub.
Table 1. System and Commissioning LED Indicators
LED
Color
If multiple errors are present, the system status LED will display each active
condition for one second on and one second off.
The system will continue to cycle through all active conditions.
System status errors are displayed in the following priority: HVAC alerts,
thermostats and then Wi-Fi.
Table 2. Communication Error Troubleshooting
(HD Display to Smart Hub)
Possible Connection Issues
One communication wire at either the
HD Display or smart hub A or B termi-
nals is disconnected.
Both communication wires – at either
the HD Display or smart hub A or B
terminals are disconnected.
Power wires at either the smart hub or
HD Display 12V+ and 12V- terminals
are disconnected.
If terminals are connected correctly,
then check HD Display. HD Display not
be secured correctly to subbase.
4
Status Description
E30 Smart Hub - System Status
LED
Flashing Magenta LED
Flashing Magenta LED
Flashing Magenta LED.
Flashing Magenta LED.
HD Display screen may be either
blank or a message indicating
iComfort cannot communicate with
the equipment.