Service; Alternative Method - Lennox iComfort E30 Installation And Setup Manual

NOTE: Once commissioning is completed you may reattach the HD Display
to the subbase.
3. Go to the smart hub and press the commissioning button located on the
side of the unit.
4. The commissioning status LED will start blinking green for two minutes.
During this time the smart hub will broadcast its Wi-Fi identifier (SSID).
5. Go to your mobile device's Wi-Fi connection tool and locate the smart
hub Wi-Fi broadcast identifier. A typical example of a identifier (SSID) is
DIRECT-XY12-3456.
NOTE: Refer to your mobile device's owners manual on how to use your Wi-Fi
Connection tool.
6. Connect to the smart hub by using the last eight digits of the smart hub
SSID as the password. In this example, it would be XY123456).
7. Once the mobile device is connected to the smart hub, the commissioning
Status LED will turn solid green.
8. Start the iComfort Mobile Setup application and make sure you are
connected to the correct smart hub by checking the serial number.
9. Touch the remote-in tab on the iComfort Mobile Setup application home
screen. This will take you to the commissioning screen.
10. You can use the information provided in "Commissioning or Service
(Using the Mobile Setup Application)" on page 13 to complete the
commissioning process using the iComfort Mobile Setup application.
11. If the system has not been commissioned it will go to commissioning
screen. If the system has already been commissioned it will go to dealer
control center.
12. Once the commissioning is completed, exit the iComfort Mobile Setup
application.
13. Go to the mobile device's Wi-Fi tool and manually disconnect from the
smart hub.
14. Once disconnected, the smart hub commissioning LED turns to a solid
blue.
15. Reinstall the HD Display on the subbase.

Service

To use iComfort Mobile Setup application as a service tool, the commissioning
of the system must have already been completed.
1. Download and install the iComfort Mobile Setup application if not already
installed.
2. Go to the smart hub and press the commissioning button once.
3. The LED will start blinking green for two minutes. During this time the
smart hub will broadcast its Wi-Fi identifier (SSID).
4. If this is the first time connecting to the target smart hub then go to your
mobile device's Wi-Fi connection tool and locate the smart hub Wi-Fi
broadcast identifier. A typical example of a identifier (SSID) is DIRECT-
XY12-3456.
5. If your mobile device had already connected previously to the target smart
hub, then touch the applicable smart hub SSID on the list and skip to step
7.
NOTE: Refer to your mobile device's owners manual on how to use your Wi-Fi
Connection tool.
6. Connect to the smart hub by using the last eight digits of the smart hub
SSID as the password (XY123456) for example.
7. Once connected to the mobile device the smart hub commissioning LED
will turn solid green.
8. Start the iComfort Mobile Setup application and make sure you are
connected to the correct smart hub by checking the serial number.
9. Touch the remote-in tab on the iComfort Mobile Setup application home
screen.
10. If the system has not been commissioned it will launch the commissioning
screen. If the system has already been commissioned it will go to dealer
control center.
11. Once servicing is completed, exit the iComfort Mobile Setup application.
12. Go to the mobile device's Wi-Fi tool and manually disconnect from the
smart hub.
13. Once disconnected the smart hub LED will change to a solid blue.

Alternative Method

From the home screen, go to menu > settings > advanced settings > pair
smart hub to iComfort dealer mobile application selection. It will auto connect
to dealer application and start you at the dealer control center screen. The
following screen will appear and show the status of the connection. Once
connected the screen will automatically disappear.
14