Installation Checklist - Lennox iComfort E30 Installation And Setup Manual

Smart thermostat

Hide thumbs Also See for iComfort E30:

Table of Contents

Installation Checklist

Smart Hub Checks:

Is the smart hub properly mounted to either a wall stud or wall?

NOTE: Do not mount on equipment or ductwork.

Is communication status LED (green) visible when hinged cover is closed?

NOTE: When LED is active it indicates that 24VAC is present at the smart hub. It also indicates communication is active between smart

hub and HD Display.

Is blinking communicating green LED seen (located in center of smart hub) when cover is open?

Are all terminal wiring properly connected and tight?

Are jumpers set to proper equipment type and number of stages?

When required, is either or both the discharge (DATS) and outdoor air temperature (OATS) sensors properly connected and isolated

when used?

Are all terminal wiring properly connected and tight?

Is the HD Display properly placed and connected to subbase?

Are all terminal wiring properly connected and tight on subbase?

Is the screen blank after initial power-up?

NOTE: The HD Display may take up to three minutes before anything appears on the screen due to a HD Display low battery condition.

HD Display battery charging only occurs when connected to the subbase.

Is the Wi-Fi connected?

Can the homeowner access the consumer portal (www.myicomfort.com) from either a PC or tablet?

Has the homeowner downloaded the Lennox Thermostat application from either Google Play or IOS App Store to their mobile devices?

Is the Lennox Dealer account number or your main shop phone number been added to the dealer information screen?

Has a complete system test been run? If not, from the HD Display home screen go to settings > advanced settings > view dealer

control center > and select tests.

HD Display Subbase Checks:

HD Display Checks:

System Checks

YES NO

Table of Contents