Multiple Smart Hub(S) - Group Id; Restarting Smart Hub; Commissioning (Using The Hd Display); Boot-Up Screen - Lennox iComfort E30 Installation And Setup Manual

settings settings
wi- wi- local local
smart away smart a aw w ay y on
Feels L Feels Like Like e o
fan fan auto
heat & cool heat & co o o o l
humidity humid ity y
iHarmo iHarmony zoning ony y zo o n
noti cations noti ca ati i ons
genera general al
display display y
Figure 18. Pairing
home info home info
account account

Multiple Smart Hub(s) - Group ID

Multiple smart hubs in a home can be assigned to a group (up to nine groups
with up to five (5) smart hubs in each group). All smart hubs in a group can
communicate with other smart hubs in the same group over the home Wi-Fi
network.
Default Group ID 1. Range is 1 to 9.
NOTE: If a smart hub is set to Group 0, then there is no connectivity with
another smart hub.
Group IDs can be changed by going to menu > settings > advanced settings
> view > dealer control center > equipment > smart hub.

Restarting Smart Hub

Pressing the smart hub button for more than five seconds will reboot the smart
hub.

Commissioning (Using the HD Display)

The following procedures are written for commissioning the system using the
HD display interface.
When power is applied the system will use the smart hub configured equipment
settings and factory defaults. All non-communicating equipment must be added
in the "add non-communication equipment" screen.

Boot-up Screen

When power is applied to the system, the HD Display will display a welcome
screen.
If there is an issue with communication between any component attached to
the thermostat, a critical alert message will appear on the screen. The alert
message will provide detail information concerning the possible cause. Once
advanced settings advanced settings
view dealer dashboard view i d d eal l er d d a h shb b oard d
now broadcasting...
restart
Connect to the Smart Hub from
the dealer iComfort mobile app
pair Smart Hub to icomfort dealer mobile app
stop
the issue is corrected and power is restored to the system the first screen in
the initial setup sequence will appear.
Sometimes there is a communication delay between the HD Display and
smart hub during initial boot-up which will result in the reference message
being display. Please wait up to one minute to see if the communication delay
is resolved.
Below is an example of a communication error message.
IComfort cannot communicate with the equipment
IComfort is unable to connect to the Smart Hub device
Figure 19. Communication Error Message

Apple HomeKit Wi-Fi Accessory Configuration

A pop-up screen will appears providing instructions on how to connect the
thermostat to the home Wi-Fi network using an Apple IOS device. If you wish
to use this method to configure the unit for Wi-Fi and Apple HomeKit, then refer
to the provided user guide for additional instructions.
Otherwise, select cancel to proceed with the thermostat commissioning
procedures. There is an option to perform this task later on at the homeowners
convenience.
NOTE: This procedure can only be accomplished using the homeowner's
Apple mobile IOS device.
15
IMPORTANT
alert
If problem persists, please contact your iComfort dealer at
1-800-555-8888
For additional support, contact Lennox at
1-800-9-LENNOX or visit www.lennox.com/support