Setting The Date And Time - Xerox WorkCentre 480cx User Manual

Print the 480cx User Guide

Setting the Date and Time

The current date and time are shown in the display when the machine is on
and ready for use (Standby mode). The date and time are printed on all faxes
you send.
1
Press the Menu button, then press the Date & Time button on the one-
touch keypad. The current date and time are displayed. A flashing
cursor in the display prompts you to enter the date.
2
Using the number keypad, enter the current date using a MMDDYYYY
date format. If you make a mistake, use the right and left buttons to
move the cursor to the digit you wish to change.
After entering the date the flashing cursor will move into the first digit
of the time.
3
Using the number keypad, enter the current time. Remember to enter
the time according to the current Clock Mode setting (12 or 24 hour
format). Refer to the previous section, CLOCK MODE for details.
4
Press Enter when the date and time settings displayed are correct.
The display indicates the date and time you have set, then returns to
Standby mode.
Note: If an invalid number is entered, the machine beeps and does not
proceed to the next step. If this happens, enter the correct number.
12-03-1998
04:06 (PM)
System Setup 1-45
1