Reception Modes - Xerox WorkCentre 480cx User Manual

Print the 480cx User Guide

Reception Modes

When used as a Stand Alone fax machine, your multi-function machine has
four reception modes as described below:


FAX The machine answers an incoming call and immediately goes
into fax receive mode.


TEL/FAX The machine answers the incoming call. If a fax signal is
not detected, the WorkCentre 480cx sounds a ringing tone to indicate a
voice phone call. If the external phone is not lifted while the ringing
tone is sounding, the machine will switch to automatic fax reception
mode.


TEL In TEL mode, automatic fax reception is turned off. You can
receive a fax only by manually picking up the external phone to accept
the call and then pressing the Start/Enter button to receive the fax.


ANS/FAX To use the ANS/FAX mode, you have to attach an
answering machine to the EXT jack on your fax machine. If the
WorkCentre 480cx senses a fax tone, it automatically switches to fax
reception mode. However, if a fax is not sensed, the WorkCentre 480cx
routes the call to the answering machine, and the caller can leave a
message.
4-2 Receiving a Fax