AT&T Syn248 SB35010 Installation And Configuration Manual page 78

Syn248 Installation and Configuration Guide
If the Update All Devices process does not work, you can upgrade a Deskset or Gateway
individually.
To update a single device to the latest software version:
1. In the navigation menu at left, click Device Management, then Update Device.
2. In the Update Device list, select a Gateway or Deskset to update.
The current software version for that device appears.
3. Click
If there is an update available on the Internet, the message "There is new software
available" appears. Click
OR
In the Manual Update section of the page, click
acquired upgrade file. You may have obtained an upgrade file from a product support
specialist. Once you have selected the upgrade file, click
specified device restarts.
4. After the device restarts, check the software version number at the device to confirm
that the upgrade was successful.
On a Deskset, press
On a Gateway, press SELECT, SELECT and DOWN. Check the SW Ver.
System Configuration
Using requires a minimum Internet download bandwidth of
1 Mbps and an Internet router that can handle the same number of total
simultaneous connections as the number of Syn248 devices. Refer to your
router specification. Performing an update without meeting the minimum
requirement may cause some or all devices not to update correctly. See
"System Upgrade" on page
The total time to update all the devices varies. The update time depends on
Internet connection speed, the number of connections to the server, and the
number of devices in the system. AT&T recommends conducting system
updates overnight to reduce the impact on Deskset users.
You can only update one device at a time. Only the selected device is
updated.
.
(MENU), then 4. Check the Software Ver.
If the device is sluggish or unresponsive during the upgrade process, see
Syn248 device becomes sluggish or unresponsive during or immediately
after software upgrade." on page
When an updated device restarts with the new software, it may disappear
from the device list if its software version is incompatible with the device
whose IP address was used for logging on to the WebUI.
77
112.
. The specified device restarts.
to select a previously
112.
Back to Contents
. The
"A