User Webui - AT&T Syn248 SB35010 Installation And Configuration Manual

Syn248 Installation and Configuration Guide

User WebUI

Unable to access the WebUI Log-in page from my computer.
Probable Cause
The computer is not
connected to the same
subnet (network) as the
Deskset, and the subnets are
not set up to communicate.
The local address, rather
than the network IP address,
was used in the address line
of the browser.
Changes made to System Configuration from the WebUI are not saved.
Probable Cause
each page to confirm the
changes.
Troubleshooting
Corrective Action




Corrective Action
must be clicked on

Verify the IP address. You must correctly enter
the IP address of your Deskset into your Internet
browser's address bar. At the Deskset, press
(MENU) –> 4 to see the IP address
displayed in the third line of the information.
Ensure that there is an LAN cable attached to
Network port on the Deskset and to the LAN. If a
PC at the same workstation is sharing the LAN
connection, attach a network cable to your
computer's network port and to the PC port on
the back of the Deskset.
Confirm that your computer and your Deskset are
on the same subnet so that they can talk to each
other. Check that the first three sections of each
IP address are the same. If they are not, they may
not be connected to the same subnet. Contact
the installer; the subnets may not be set up to
communicate.
Use the network IP address assigned through
DHCP or manually in the address bar of the
browser.
Click on each page to confirm the
changes.
113
Back to Contents