System Settings; Changing The System Basic Settings - AT&T Syn248 SB35010 Installation And Configuration Manual

Syn248 Installation and Configuration Guide

System Settings

After you log on to the WebUI as the administrator with a Gateway or Deskset IP address,
you can make changes to the system or to individual Desksets.
The System Settings covered in this chapter include:
"Changing the System Basic Settings" on

page 39
"Configuring the Auto Attendant" on

page 42
"Configuring Hold Settings" on page 49

"Overhead Paging" on page 51


Changing the System Basic Settings

To view or modify the System Basic Settings:
1. In the navigation menu at left, click Basic Settings.
The System Basic Settings page appears.
2. If necessary, change the Administrator Account. The Administrator ID can be up
to 16 characters long. The Administrator Password is limited to four to six digits.
Values outside this range generate an error message.
3. Select the Operator Extension. Any Deskset can be designated as the system
operator. The default is Extension 200. The Operator can select the current Auto
Attendant menu. See
external calls are forwarded to the operator extension if the caller presses 0 (zero)
after the Auto Attendant answers or when callers reach an extension's voicemail.
Deskset users can call the operator by pressing 0 from an active intercom line.
System Configuration
When making changes to the System Settings through the WebUI, ensure that
no one is using the system. To ensure the system is idle, you might need to
make the changes outside of normal office hours.
"Configuring the Auto Attendant" on page
"Configuring Phone Line CFNA" on

page 53
"Creating, Editing and Deleting

Paging Zones" on page 55
"System Directory" on page 57

"Line Naming" on page 58

39
Back to Contents
42. As well, incoming