Syn248 Installation and Configuration Guide
To install the Deskset on a wall:
1. Plug the Ethernet cable into the port on the back of the Deskset. (See
the Deskset to the network:" on page
2. Plug the power adapter into the jack on the back of the Deskset. Skip this step if
using PoE. (See
3. Place the Deskset base over the mounting plate as shown in
onto wall-mount screws with centers 3 ¼ inches (8.2 cm) or 4 inches (10.2 cm) apart.
Most standard wall plates have screw centers 3 ¼ inches apart.
4. Slide the Deskset base down as shown in
5. Plug the Ethernet cable into the LAN switch or wall jack.
6. Plug the power adapter into a power outlet not controlled by a wall switch. Skip this
step if using PoE.
7. Make sure the handset tab is in the wall position, as described in
handset tab for wall and Deskset Option 2 installation:" on page
8. Connect the handset to the handset jack on the left side of the Deskset.
Installation
24.)
"To connect power:" on page
22
Back to Contents
25.)
. The Deskset will fit
.
Wall-mount screws
with centers 3 ¼ or
4 inches apart
"To rotate the
21.
"To connect