Gateway Configuration - AT&T Syn248 SB35010 Installation And Configuration Manual

Syn248 Installation and Configuration Guide

Gateway Configuration

Press UP or DOWN in the Gateway main menu until Configuration is highlighted, as
shown in Figure 24, and press SELECT to display the Configuration menu. The current
setting is indicated with [*].
Configuration — Current Gateway settings.
Auto IP — Is set automatically.

Static IP — You can change the static IP only from the Gateway. See your

network administrator if you require details regarding IP assignments.
Restore Defaults — Highlight Restore Defaults and press and hold SELECT for

two seconds when prompted to restore the Gateway to factory defaults.
Upgrade Software — Highlight Upgrade Software and press SELECT. If new

software is available, you are prompted to press SELECT again to accept the
upgrade. You can use this interface or the WebUI to upgrade software.
Setting a Gateway Static IP Address
To configure a Gateway with a static IP address:
1. On the Gateway front panel, press SELECT.
2. Press the down arrow button to highlight Configuration and press SELECT.
3. Highlight Static IP and press SELECT.
4. Enter the static IP address for the Gateway. An IP address consists of four "octets."
Each octet is usually represented by three digits. For octets with less than three
digits, omit digits by leaving them at zero. For example, you would enter
192.168.0.20 as 192.168.000.020.
Change each number with the up and down arrow buttons and press SELECT to

move to the next number.
Device Configuration
Figure 24. Gateway Configuration
86
Back to Contents