Call Detail Report For Incoming Calls; Call Detail Report Filter - Siemens HiPath 1100 Series Programming Manual

Step by Step

Call Detail Report for Incoming Calls

If the system is enabled for Caller ID over digital (E1
CAS) or analog lines by a local carrier, the call informa-
tion will be displayed on the Call Detail Report.
The columns "Ext" (Extensions), "Ring" (Ring Duration),
"Duration" (Call Duration) and "Call fees" (Pulses) remain
empty while the column "I" (Type of Call) shows an " * "
next to the call.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
6 1
... Enter the code for the type of Call Detail Report.
1 4
= Outgoing calls are recorded at the end of the call.
1
Incoming calls (with or without Caller ID at the
source) are recorded at the end of the call
(default).
= Outgoing calls are recorded at the end of the call.
2
= Outgoing calls are recorded at the end of the call.
3
Incoming calls with Caller ID at the source are
recorded at the beginning of the call.
Incoming calls (with or without Caller ID at the
source) are recorded at the end of the call.
= Outgoing calls are recorded at the end of the call.
4
Incoming calls with Caller ID at the source are
recorded at the beginning of the call.
Initial state for Programming Mode.
Caller ID service must be contracted with a local
carrier.

Call Detail Report Filter

The number programmed in this filter specifies the type
of outgoing call to be recorded, based on the first four
digits of the dialed number.
For example, in order to record only international outgo-
ing calls, you must program the digits "00."
The maximum number of digits is 4.
Call Detail Report Manager
105