Language; Country/Group Of Countries; Enter The Code For Programming; Initial State For Programming Mode - Siemens HiPath 1100 Series Programming Manual

Step by Step
0 1
Enter the next extension number
or
Press this key.
#

Initial state for Programming Mode.

Language

Select the desired language for displaying messages on
the system telephones. The field is updated automati-
cally according to the selection entered in the Country
field. Note that when you change the language field the
country field is not changed. It is possible, therefore, to
select a country with a different default language. For
example, Country: Brazil, Language: English.

Required: Programming Mode must be active (*95

31994).

Enter the code for programming.

6 4
...
Select the language for displaying messages.
0 4
= Custom
0
= Portuguese
1
= Spanish
2
= English (default)
3
= French
4
Initial state for Programming Mode.

Country/Group of Countries

To configure the settings correctly select the country
where the system will be used.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
6 5
... Enter the code for the country or group of countries as
3 1
shown on the table below (e.g., "03" for Portugal).
The system restarts after the change is made.
Main Configurations
27