Siemens HiPath 1100 Series Programming Manual page 96

General Programming
Step by Step
*
96
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
5 7
or Activate/Deactivate remote configuration:
* #
= To deactivate remote configuration
*
= To deactivate remote configuration
#
Initial state for Programming Mode.
Replace the handset.
Required: Remote Configuration must be enabled and
the programming extension must have a conversation
in progress on the external line that will be used for the
remote configuration.
With a conversation in progress enter the programming
9 9 1
extension code to transfer control of the HiPath 1100 to
the remote programmer.
The remote programmer must now enter the system
password using an MF telephone (default - 31994).
Wait for a confirmation tone to indicate that the
password was accepted.
To set the required configuration, proceed as if the
remote telephone was directly connected to the
system.
If a Fax/DID Module is Installed.
If the HiPath 1100 is equipped with a Fax/DID module
configured to answer external lines.
Enter the code using a remote MF telephone after the
* 9 5
call is answered.
The remote programmer must now enter the system
password using an MF telephone (default - 31994).
Wait for a confirmation tone to indicate that the
password was accepted.
To set the required configuration, proceed as if the
remote telephone was directly connected to the
system.