Assigning An External Number To An Extension - Siemens HiPath 1100 Series Programming Manual

Step by Step
...
0 0 1
...
0 0 1
...
0 0 1
...
0 0 1
Assigning an External Number to an
Extension
The external numbers registered for each slot (see
"MSN and Extension Assignment - Code 086") must be
assigned to extensions or Call Groups designated for
answering calls during a specified period of time.
Each extension can only be entered once. A distinctive
tone on the handset indicates an invalid entry.
In the default configuration there are no extensions
assigned to any slots.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
9 2
Enter the external number slot.
1 4 0
... Select a period of time:
1 4
= Day, incoming
1
= Day, outgoing
2
= Day, incoming, after a specified period of time.
3
= Night, incoming, after a specified period of time.
4
Enter the extensions or Call Groups (CG, HG or UCD -
up to 10 extensions per group. For example, 11/770,
780 or 790).
Enter the next slot.
1 4 0
or
Press this key.
#
Initial state for Programming Mode.
Deleting an Extension Number
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
9 2
Enter the external number slot.
1 4 0
* Press the key to remove it.
Enter the next slot.
1 4 0
Programming a Digital Trunk
123