RS-422 Interface
Hood Assembly
5-6-5 Insertion and Removal of Connector
92
Assemble the connector hood.
End connected
to FG
It is extremely important to hand-hold the connector to attach and insert it prop-
erly. After inserting the connector, take a Phillips head screwdriver and fully
tighten the two lock screws.
Phillips head
screwdriver
(for M2.6)
To remove the connector, completely unscrew the two lock screws, and take out
the protruding section of the connector hood by hand and pull it straight out.
If it is difficult to remove, hold the ID Controller down with one hand and pull care-
fully on the connector with the other.
Aluminum
foil tape
End not connected
to FG
Lock screws
(Two, M2.6)
Section
5-6