Omron V600 Series Operation Manual page 90

RS-232C Interface
5-5-2 Connector Assembly
1, 2, 3...
1. Perform cable terminal processing.
40
5
Conductor lines
Shield braid
Shield tape
2. Solder conductor lines and plug pins.
Crossover
Plug
3. Set the hood housing A2 onto the plug, and fix the aluminum tape section
with a clamp.
Lock screw (2-M2.6)
Housing A2
Cable clamp
4. Tighten the two connector holding screws, and then cover this with housing
B2 to complete the connector assembly.
Note 1. First pass the cable through the cable bushing.
2. Unwind the shielded braid and turn back over the cable bushing. Unwind 10
mm of the shielded braid and turn back over the cable bushing.
3. Wrap the lines with sealing tape.
Pin no.
1 (see note 1)
7
2
3
4 (note 2)
5 (see note 2)
20
35
Cable bushing
10 1
12
Cable bushing
Aluminum tape
Housing B2
Abbr.
GR Ground
SG Signal ground
SD Send data
RD Receive data
RS Request send
CS Can send
ER Data terminal ready
Section 5-5
Name
87