Monitor Unit Operation List - Omron V600 Series Operation Manual

Monitor Unit Operation List

4-2 Monitor Unit Operation List
4-2-1 Basic Operations
Operation mode
Changing operation Switches ID Controller
mode operation mode
Job specification Specifies head and page
numbers required for given
operations
Numerical keys Used for setting address,
specifying data, and
selecting functions
Address setting Sets the address from
which data is read or to
which data is written in the
range 00 to FF.
Data specification Specifies the 8-bit data (00
to FF) to be written to the
DC.
Note 1. Data setting is not required for an operation test with the test read or test
auto read command to check the relationship of the position.
2. If the DC's memory capacity is more than 256 bytes, data cannot be written
to address 00 or 01 when page 0 is set with a page number because these
addresses are used to register the production month and year of the DC.
Nothing can be written to addresses 0002 to 0005 because these addresses
are used as a write protected area.
If the DC's memory capacity is 256 bytes or less, no data can be written to
or
address 00 when page 0 is set with a page number because this address is
used as a write protected area.
Description
MONITOR Mode
Note Monitor Unit read and write data is limited to HEX code.
Basic operation procedure
RUN Mode
MONITOR
JOB INC SET
Head no. setting
Address and data specifications
to
o F
Upper digit
Function selection
1 to 4
Start address
o to F o
ADRS
Upper digit Lower digit
End address
to
o
ADRS
Upper digit
to
o F
DATA
Upper digit
Section
or
RUN
RUN
INC INC SET
Page no. setting
to
o F
Lower digit
to F
to
F o F
Lower digit
to
o F
Lower digit
4-2
Page
59
60
60
61
62
57