Omron V600 Series Operation Manual page 68

Data Read and Write Operations
4-4-2 Step Write
Operation Procedure
1, 2, 3...
This is used to write one byte of data to the desired DC address.
Job specification
Head no. setting
Page no. setting
Address setting
F E
ARDS
DATA
3
C
WRITE S WRITE?
1
SWaFEd3C
SET
Step write display
(Cancel operation by pressing
The step write operation writes the job specification head and page numbers.
1. Specify the address.
Note Page 0 addresses 00 and 01 are reserved for registration of the pro-
duction data (year, month, day), and data cannot be written in this
area. Note also when using this function that addresses 02 to 05 are
write protected (see page 22).
2. Press the DATA Key and specify one byte of data (two hexadecimal digits).
3. When the WRITE1 Key is pressed, "S–WRITE?" is shown at the left end of
the display.
4. When the SET Key is pressed, data is written to the specified DC address.
Note If no R/W Head is connected, if the DC is not in the communications
range, or if a communication error occurs, an error code is displayed
(see page 97). When this happens, use the horizontal cursor keys to
display the error message.
aFEd
_
aFEd3
(2)
_
aFEd3C
)
RESET
Section 4-4
65