Omron V600 Series Operation Manual page 87

Serial interface id controller

Hide thumbs Also See for V600 Series:

Table of Contents

DIP Switch Settings

Note

1. Set the data length to 7 bits to select the ASCII code and 8 bits to select the

JIS 8-digit code.

2. Set the parity setting to E to designate the even parity and O to designate the

odd parity. Set the parity setting to N if no parity is designated.

Note It is extremely important to turn off the power to the ID Controller before making

the DIP switch settings. DIP switch settings are acted upon at power supply

startup, and consequently changing DIP switch settings while the system is in

operation will have no effect.

Section

5-4

Table of Contents