Pri Commands (Ld 60) - Avaya CS 1000 Maintenance Manual

Primary Rate Interface maintenance

PRI commands (LD 60)

Primary Rate Interface (PRI) diagnostic commands are used to maintain both PRI and clock-
controller operation. See
for a list of the PRI card and channel commands in LD 60. The commands are organized as
follows:
• PRI card and channel commands
• Alarm and counter commands
• Test commands
Table 10: PRI card and channel commands in LD 60
Command
DISI L
DISL L
DSCH L CH
ENCH L CH
ENLL L
STAT
STAT loop
40 ISDN Primary Rate Interface Maintenance
Table 10: PRI card and channel commands in LD 60
PRI loop L is disabled only when all the channels are idle. The network
and PRI cards are then disabled and status LEDs are lit. Channel status
is set to busy. Enter END to abort.
Disables network and PRI circuit packs of loop L. Active calls are
automatically disconnected by on-hook simulation. All channels are
disabled and status LEDs are lit.
All channels of loop L are disabled.
All channels of loop L are enabled.
Enables PRI loop L. Channel CH of PRI loop L is enabled. The channel
is placed into the idle state and made available for calls.
Prints the status of all digital loops.
Get status of digital loop. Sample output:
AAA TRK LOOP x - BBBB SERVICE RESTORE: YES/NO YEL ALM
PROCESS: YES/NO ALARM STATUS: NO ALARM/RED(local) ALARM
Where: AAA may be:
DTI
DTI2
PRI
PRI
TIE
DID
DTI LINK (DTI link loop = DLI)
Where: BBBB may be:
DSBL = Hardware of specified digital loop is disabled
ENBL = Hardware of specified digital loop is enabled
RLBK = Hardware of specified digital loop is in remote loop back mode
DISI PENDING = DSI command is in progress
TRACKING = System clock is tracked to this loop
Comments? infodev@avaya.com
Description
on page 40
November 2011