Command
RCNT (L)
SLFT (L)
STAT (L)
RLBK L (C)
DLBK L (C)
RMST L (C)
PRI status and error conditions are reported in the Primary Rate Interface messages in Avaya
Software Input Output Reference - System Messages (NN43001-712).
DCHI commands
D-channel commands are found in LD 96.
a quick-reference list of D-channel commands.
Table 80: DCHI commands
Command
DIS DCHI N
ENL DCHI N
EST DCH N
PLOG DCHI N
RLS DCH N
SDCH DCH N
RST DCH N
STAT DCH (N)
TEST 100/101
STAT SERV
ENL SERV N
DIS SERV N
D-channel status and error conditions are reported as DCH messages. These messages can
be found in the Avaya Software Input Output Reference - Maintenance (NN43001-711).
ISDN Primary Rate Interface Maintenance
Reset alarm counters and clear alarms.
Do 2.0 Mb PRI self-test (2.0 Mb PRI must be disabled first).
List 2.0 Mb PRI status.
Enable remote loopback.
Disable remote loopback.
Perform remote loopback.
Table 80: DCHI commands
Disable DCHI port N.
Enable DCHI port N.
Establish D-channel N.
Print D-channel statistics log N.
Release D-channel N.
Release a D-channel and switch D-channels.
Reset D-channel N.
Print D-channel status (link status).
DCH tests.
Print the current service and service acknowledge message for
DCHI N.
Enable service messages for DCHI N.
Disable service messages for DCHI N.
System PRI maintenance tools
Action
on page 159 provides
Action
November 2011
159