Avaya CS 1000 Maintenance Manual page 60

D-channel maintenance
ENL SERV x
EST DCH x
EST ISPC l ch (N)
FDIS NCAL <DCH#> <conn_ID>
PLOG DCH x
RLS DCH x
RLS ISPC l ch
RST DCH x
RST MON
SDCH DCH x
SET MSGI x MON (0)-2
SET MSGO x MON (0)-2
SLFT TMDI x
STAT DCH (x)
STAT ISPC l ch
STAT NCAL <DCH#>
STAT NCAL <DCH#> <conn_ID>
STAT MON (x)
STAT SERV (x)
STAT TMDI (x FULL)
60 ISDN Primary Rate Interface Maintenance
Command
Comments? infodev@avaya.com
Description
Enable service messages on D-channel x.
Establish multiple frame operation on D-channel x.
Start the data interface establishment process at the
ISPC slave side an ISPC link (where "N" = the "number
of tries" counter).
Force disconnect the specified call-independent
connection.
Print protocol error log on D-channel x.
Release D-channel x.
Stop the data interface establishment process.
Reset D-channel x, inhibit signaling.
Reset or reactivate monitoring on D-channels with
enabled monitors.
Switch to the standby D-channel x.
Set monitor output format level for incoming messages
on D-channel x.
Set monitor output format level for outgoing messages
on D-channel x.
Invoke self-test x
Get status of one or all D-channels
Get status of data interface establishment process at
ISPC slave side ISPC link which has been configured
to convey D-channel signaling.
List all current call-independent connections on a
given PRI D-channel.
List information pertaining to a specific call-
independent connection.
Display the incoming and outgoing monitoring status
of one or all D-channels.
Get the enable/disable status of services messages
for one or all D-channels.
Get TMDI status x.
November 2011