Pri Alarm Commands - Avaya CS 1000 Maintenance Manual

Command

PRI alarm commands

See Table 11: PRI alarm commands in LD 60
and descriptions of these commands. These commands appear in LD 60.
Table 11: PRI alarm commands in LD 60
Command
CDSP
CMIN C
CMIN ALL
ISDN Primary Rate Interface Maintenance
IDLE = Hardware of specified digital loop is idle
When AAA = TIE, IDLE ISPC indicates that the channel is an established
ISPC link ready to be used by any end users having access to the
associated ISPC route.
SERVER RCVY = server has not recovered status of DTI LINK loop.
Channels will not be allocated for call processing until this status is
removed by the server
BUSY = Hardware of specified digital loop is busy
When AAA = TIE, BUSY ISPC indicates that the channel is an
established ISPC link which is used by end users on the PBXs.
When AAA = DID, BUSY ISPC indicates that the ISPC link is established
to the Central Office. The status "BUSY" is independent to ISL feature
usage of the ISPC link.
MBSY = Hardware of specified digital loop is in make busy mode
When AAA = TIE, MBSY ISPC indicates that the configured ISPC link is
one of the following:
a not established yet
b established, but the ISL D-channel which controls its usage not
established
Where: SERVICE RESTORE may be:
YES = restore service automatically if alarm is removed
NO = loop can only be manually enabled
Where: YEL ALARM PROCESS may be:
YES = Yellow alarm processing is enabled
NO = Yellow alarm processing is disabled
Where: ALARM STATUS may be:
NO ALARM = no alarm active
RED = Red (local) alarm active
Clears the maintenance display on active CPU to 00 or blank.
Clears the minor alarm indicator for customer C.
Clears the minor alarm indicators for all customers.
Description
on page 41 for a list of PRI alarm commands
Description
PRI alarm commands
November 2011 41