Telnet And Ftp Security; The Itg Shell - Nortel Meridian 1 Description, Installation And Operation

Page 196 of 262
7HOQHW#DQG#)73#6HFXULW\
'RZQORDG#WKH#,7*#RSHUDWLRQDO#PHDVXUHPHQWV#WKURXJK
WKH#,7*#VKHOO
553-3001-119 Standard 2.00 April 2000
Administration
Good security policy requires changing user names and passwords
periodically. The ITG user name and password protects FTP and Telnet
access to the IP Line card over the LAN.
From the ITG shell use the command shellPasswordSet to change the
1
default user name and password for Telnet to ITG shell and FTP to the
IP Line card file system. The default user name is itgadmin and the
default password is itgadmin .
You will be prompted for the current user name:
Enter current username: itgadmin
Enter current password: itgadmin
Enter new username: newname
Enter new password:newpwd
Enter new password again to confirm: newpwd
If the entire sequence of commands is successfully entered, you get the
system response with 'value = 0 = 0x0'. The new user name and password are
now stored in the non-volatile RAM on the IP Line card, and will be retained
even if the card is reset, powered-off, or on.
The IP Line card operational measurements file contains counts of incoming
and outgoing calls, call attempts, calls completed, and total holding time for
voice calls. To download this file from the MAT PC to the IP Line card:
At the ITG shell prompt, type:
SDVVZRUG/#GLUHFWRU\#SDWK/#ILOHQDPH
?KRVWQDPH/#XVHUQDPH/#SDVVZRUG/#GLUHFWRU\#SDWK/#ILOHQDPH
file.
The Gatekeeper OM file contains information about the Gatekeeper and its
endpoints' activities.
FXUU20)LOH3XW ?KRVWQDPH/#XVHUQDPH/#
> for the current file, or
SUHY20)LOH3XW
> for the previous