Nortel Meridian 1 Description, Installation And Operation page 109

Type +++ and then press Enter . Enter the default "user ID" and
3
"password" of itgadmin to access the ITG shell command line prompt:
...+++
user ID: itgadmin
password: itgadmin
ITG>
4 When the ITG shell prompt appears on the TTY, enter the IP address for
the Leader card:
Wait until the display shows "T:21," then enter:
setLeader "xx.xx.xx.xx","yy.yy.yy.yy","zz.zz.zz.zz", and
press Enter . Where:
"xx.xx.xx.xx" is the IP address of the management interface on Leader 0,
where "yy.yy.yy.yy" is the Gateway IP address for the management
interface on Leader 0.
and where "zz.zz.zz.zz" is the subnet mask for the management interface
on Leader 0.
³VHW/HDGHU´#SDUDPHWHUV#GHVFULSWLRQ
All ITG shell commands are case-sensitive. The three parameters must each
be enclosed in quotes, and that there must be a comma and no spaces between
the "xx.xx.xx.xx" and "yy.yy.yy.yy" parameters and between the
"yy.yy.yy.yy" and "zz.zz.zz.zz" parameters.
*DWHZD\#,3#DGGUHVV
The
network route only if 1) there is no active leader that has this card's MAC
address in its bootp.1 file, and 2) this card's bootp.1 file is empty (size 0 Kb).
IP addresses and subnet masks must be entered in dotted decimal format. The
VXEQHW#PDVN
may be expressed in Classless Inter-Domain Routing (CIDR)
format, appended to the IP address. For example 10.1.1.1/20. To convert
subnet mask from CIDR format to dotted decimal format refer to Appendix C.
Leader 1 card will automatically be set as a leader after node properties are
successfully transmitted.
Reboot the Leader 0 IP Line card.
5
ITG Line 1.0/IP Telecommuter Description, Installation and Operation
Installation and configuration
is used on reboot to create IP route table default
Page 109 of 262