Itg Shell Commands - Nortel Meridian 1 Description, Installation And Operation

ITG shell commands

Table 14
ITG Shell Commands
Command
General-Purpose Commands:
shellPasswordSet
itgCardShow
itgChanStateShow
itgHelp
ldrResTableShow
itgMemShow
ifShow
IPInfoShow
dongleIDShow
serialNumShow
firmwareVersionShow
numChannelsShow
The ITG shell commands are accessed by connecting a TTY to the MMI port
on the IP Line card faceplate. Alternatively, the MAT ITG "Telnet" command
can be used to access the ITG shell. Commands are grouped into six
categories are shown in Tables 14 through 22.
Change the default ITG shell password.
Show card info.
Show state of channels. eg. busy or idle.
Shows the complete command list. "?" also shows the
list.
Show backup leader and followers for a given leader.
Show memory usage
Show detailed IP information, including MAC address-
es.
Prints IP information.
Prints out dongle ID.
Prints out card serial number.
Prints out firmware version number.
Prints out number of available channels.
ITG Line 1.0/IP Telecommuter Description, Installation and Operation
Maintenance
Page 223 of 262
Description