Nortel Meridian 1 Description, Installation And Operation page 146

Page 146 of 262
553-3001-119 Standard 2.00 April 2000
Installation and configuration
15 Enter menu selection number 13, "Default Dial-in Setup", under the
"Advanced Applications" section.
"Menu 13 - Default Dial-in Setup " is displayed.
16 Under "Telco Options" toggle
"CLIDAuthen=None/Preferred/Required".
CLID requires a C.O. line subscribed for CLID service where available.
"Preferred" means some dial-in user profiles may require CLID, but
others may not. "Required" means no dial-in call is connected unless
CLID is provided and user profiles require CLID for authentication.
Under "PPP Options" toggle "Recv Authen=PAP". Windows 9x Dialup
Networking (DUN) is not compatible with CHAP/PAP or CHAP on the
modem router: calls are disconnected after a few minutes.
Toggle "Compression=No". Windows 9x DUN is not compatible with
software compression on the modem router: calls are randomly
disconnected.
Toggle "Mutual Authen=No".
Under "IP Address Supplied By:" Toggle "Dial-in User=No", "IP
Pool=Yes". For "IP Start Addr=" type in the E-LAN IP address that will
be assigned to the Dialup Networking (DUN) PPP client on the remote
MAT PC.
Note: The remote MAT PC will receive this E-LAN IP address
whenever DUN makes a dial-in PPP connection to the modem router. As
long as DUN remains connected to the modem router, IP applications on
the remote MAT PC function as if the PC were located on the customer's
E-LAN.
Under "Session Options" configure input and output filter sets according
to the customer's IP network security policy and practices. The default
setting is no filter sets. Set "Idle Timeout=1200" seconds to provide 20
minutes idle timeout disconnect for remote support purposes.
Press Enter to confirm and save data to ROM.
17 Enter menu selection number 14, "Dial-in User Setup", under the
"Advanced Applications" section.
"Menu 14 - Dial-in User Setup " is displayed.