Transmit Itg Configuration Information From Mat; Set The Leader 0 Ip Address - Nortel Meridian 1 Description, Installation And Operation

Page 108 of 262
7UDQVPLW#,7*#FRQILJXUDWLRQ#LQIRUPDWLRQ#IURP#0$7

Set the Leader 0 IP address

553-3001-119 Standard 2.00 April 2000
Installation and configuration
Transmitting ITG configuration information from MAT to the IP Line cards
starts with configuration of the Leader 0, and proceeds to transmitting the
node properties and Gatekeeper properties, transmitting the card properties,
and verifying that the IP Line cards have the correct software.
Connect the MAT PC com port or another terminal device to the serial
1
port on the IP Line card on the faceplate or I/0 serial maintenance port of
the NTMF94DA cable. Use an NTAG81BA Maintenance Extender
cable to provide an extension between the NTAG81CA Faceplate
Maintenance cable and the MAT PC. Alternatively, connect the
NTAG81BA Maintenance Extender cable to the female DB-9 connector
of the NTMF94AA I/O Panel Ethernet and Serial Adaptor cable to create
a more permanent connection to the IP Line card maintenance port.
Use the following communication parameters for the TTY terminal
2
emulation on the MAT PC: 9600 baud, 8 bits, no parity bit, one stop bit.
When a new IP Line card displays "T:20" on the 4-character display, the
IP Line card will begin sending bootp requests on the E-LAN. A series
of dots appears on the TTY.