Configure The Rm356 Modem Router By The Manager Menu - Nortel Meridian 1 Description, Installation And Operation

Page 144 of 262

Configure the RM356 modem router by the manager menu

553-3001-119 Standard 2.00 April 2000
Installation and configuration
Configuring the RM356 modem router by the manager menu can be
completed from a terminal or PC connected to the local RS232 manager port
on the rear of the modem router. Alternatively the manager menu can be
accessed by Telnet after the IP addressing and routing have been set up
initially from the local manager port.
Note: The arrow keys navigate in the RM356 manager menu. The
spacebar key toggles pre-defined configuration values for a field. The
Enter key saves data changes to ROM and exits the current menu. The
Esc key exits the current menu without saving changes. Enter menu
selection number when prompted to display a sub-menu, configuration
form, or command prompts.
(QWHU
Press the
1
The 'Enter Password:' prompt is displayed for 10 seconds.
2 Enter the default RM356 manager password: 1234
The "RM356 Main Menu" is displayed.
Enter menu selection number 1 to access "General Setup" under the
3
"Getting Started" section of the "RM356 Main Menu."
"Menu 1 General Setup" is displayed.
4 Type in the system name(19 characters, no spaces), location, and contact
person's name for the Meridian 1 site. Use the up and down arrow keys
to move the cursor to the prompt "Press ENTER to Confirm or ESC to
Cancel:"at the bottom of the menu . Press Enter to confirm and save data
to ROM.
5 Enter menu selection number 2 under the "Getting Started" section.
"Menu 2: Modem" is displayed.
Type in modem name. Set "Active=Yes". Use arrow keys to navigate and
6
space bar to toggle values. Set "Direction=Incoming". Type in the
modem router's telephone number for reference. Press Enter to confirm
and save data to ROM.
key.