6.2.3 Program Example When Utility Package Is Not Used - Mitsubishi MELSEC-Q Series User Manual

6
PROGRAMMING
6.2.3
(1) Device list
(2) Program example
6
- 8 6.2 Programs Used in Normal System Configuration

6.2.3 Program example when utility package is not used

Program example when utility package is not used
Device
D1 CH1 Measured temperature value
D2 CH2 Measured temperature value
D3 CH3 Measured temperature value
D4 Disconnection state monitor flag
D5 Error code
M0 to M2 Conversion completion flag
M10 Disconnection state monitor flag
X0 Module READY
XC Disconnection state monitor signal
XF Error flag
YF Error clear request
Measured temperature value read command
X10
input signal
X11 Disconnection state reset signal
X12 Error reset signal
Y20 to Y2B Error code display (BCD 3 digits)
Table 6.3 Device list
Function
\
\
\
\
\
\
\
\
\
Processing at disconnection
status confirmation
\
Q68TD-G-H01 (X/Y0 to X/YF)
QX10 (X10 to Y1F)
QY10 (Y20 to Y2F)
Conversion enable/disable setting
CH2 time/count averaging setting
CH3 time/count averaging setting
Averaging processing specification
Turns ON operating condition
setting request (Y9).
Turns OFF operating condition
setting request (Y9).
Read of conversion completion flag
Read of CH1 measured
temperature value
Read of CH2 measured
temperature value
Read of CH3 measured
temperature value
Read of disconnection state
monitor flag
Processing at CH1 disconnection
status confirmation
Turns ON error clear request (YF).
Outputs error code in BCD.
Turns ON error clear request (YF).
Turns OFF error clear request (YF)