Programming Example Using The Utility Package - Mitsubishi MELSEC-Q Series User Manual

6
PROGRAMMING
6.2.2
(1) Device list
(2) Operating the utility package
6
- 6 6.2 Programs Used in Normal System Configuration

6.2.2 Programming example using the utility package

Programming example using the utility package
Device
D1(D11) CH1 Measured temperature value
D2(D12) CH2 Measured temperature value
D3(D13) CH3 Measured temperature value
D4 Disconnection state monitor flag
D5 Error code
M0 to M2 Conversion completion flag
M10 Disconnection state monitor flag
X0 Module READY
XC Disconnection state monitor signal
XF Error flag
YF Error clear request
Measured temperature value read command
X10
input signal
X11 Disconnection state reset signal
X12 Error reset signal
Y20 to Y2B Error code display (BCD 3 digits)
(a) Initial setting (see Section 5.4)
Set the initial settings of CH1 to CH3.
Refer to Section 6.2 (3) for the settings.
Table 6.2 Device list
Function
Q68TD-G-H01 (X/Y0 to X/YF)
QX10 (X10 to X1F)
QY10 (X20 to Y2F)