Programming Procedure - Mitsubishi MELSEC-Q Series User Manual

6
PROGRAMMING
6.1

Programming Procedure

In the following procedure, create a program that will execute the thermocouple input of
the Q68TD-G-H01.
YES
Initial settings, Auto refresh
setting
(Refer to Section 6.2.2,
(Refer to Section 6.2.2,
6.3.1) Section 6.3.1)
6
- 2 6.1 Programming Procedure
Start
Use the utility package?
NO
Conversion enable/disable setting
Averaging process selection
Perform averaging
processing?
NO
Perform warning output?
NO
Output a scaling value?
NO
Procedure to judge
disconnection status
monitor?
Disconnection state monitor signal
Disconnection state monitor flag
Operating condition setting request (Y9)
processing
Measured temperature value read
End
YES
Count average
Time average
Moving average count
Time constant
<Select any of them>
YES
Warning output enable/disable
Process alarm upper/lower limit values
Rate alarm warring detection period
Rate alarm upper/lower limit values
<Set depending on necessity>
YES
Set the scaling range setting
Measured temperature value
Set the disconnection state conversion setting
Up scale
Down scale
Given value
(Set any value for the disconnection state
conversion setting)
<Select any of them>
Initial settings
(Refer to
(Refer to
Section 6.2.2,
Section
6.2.3, 6.3.2) Section 6.3.1)