6.2.3 Program Example When Gx Configurator-Ti Is Not Used - Mitsubishi Melsec-Q Series User Manual

6
PROGRAMMING
6.2.3 Program example when GX Configurator-TI is not used
(1) List of devices
Device
D11
D12
D13
X0
X9
XC
XF
Y9
YF
X10
X11
X12
Y20 to Y2B
(2) List of buffer memory addresses to be used
Address
*1
Un\G0
Un\G2
Un\G3
Un\G10
Un\G11
Un\G12
Un\G13
Un\G19
Un\G24
Un\G46
Un\G47
Un\G48
Un\G49
CH1 Measured temperature value
CH2 Measured temperature value
CH3 Measured temperature value
Module ready
Operating condition setting completion flag
Disconnection detection signal
Error flag
Operating condition setting request
Error clear request
Device that user turns on to start reading
measured temperature values
Device that user turns on to reset a
disconnection detection state
Device that user turns on to reset an error
Error code display (BCD 3 digits)
Table 6.5 List of buffer memory addresses to be used
Description
Conversion enable/disable setting
CH2 Time/Count/Moving average/Time constant
setting
CH3 Time/Count/Moving average/Time constant
setting
Conversion completion flag
CH1Measured temperature value
CH2Measured temperature value
CH3Measured temperature value
Error code
*2
Averaging processing selection (CH1 to CH4)
*3
Warning output enable/disable setting
Warning output flag (Process alarm)
Warning output flag (Rate alarm)
Disconnection detection flag
6.2 Using Programs in Normal System Configuration

6.2.3 Program example when GX Configurator-TI is not used

Table 6.4 List of devices
Function
Setting
value
00F8
H
5
960
-
0420
H
FBFD
-
Q68TD-G-H02(X/Y0 to X/YF)
QX10(X10 to X1F)
QY10(Y20 to Y2F)
Remarks
"Enable" is set to CH1 to
CH3.
Count (times) is set when
Count average is set.
Time constant (ms) is set
Primary delay filter is set.
Conversion state of a
channel is stored.
Measured temperature value
is stored.
Corresponding error code is
stored.
The following conversion
system is set.
CH1: Sampling processing
CH2: Count average
CH3: Primary delay filter
"Enable" is set for the
following warning output.
H
CH2: Process alarm
CH3: Rate alarm
Warning output state is
stored.
Disconnection state of a
channel is stored.
6
1
2
3
4
5
6
7
8
- 12