Scaling Range Upper/Lower Limit Values (Un\G62 To Un\G77); Scaling Width Upper/Lower Limit Values (Un\G78 To Un\G93) - Mitsubishi MELSEC-Q Series User Manual

Channel isolated thermocouple input module, gx-configurator-ti sw1d5c-qtiu-e, programmable controller
Hide thumbs Also See for MELSEC-Q Series:
Table of Contents

Advertisement

3
SPECIFICATIONS
3.4.17
CH[ ]
(1) Set the scaling range of the measured temperature value for each
channel in units of 0.1
(2) The default value is set to "0".
(3) Settable scaling range is -32768 to 32767.
(4) To activate the setting, turning ON/OFF the operating condition setting
request (Y9) is required.
POINT
3.4.18
CH[ ]
(1) Set a width for scaling conversion on each channel.
(2) The default value is set to "0".
(3) Settable scaling range is -32768 to 32767.
(4) To activate the setting, turning ON/OFF the operating condition setting
request (Y9) is required.
POINT

scaling range upper/lower limit values (Un\G62 to Un\G77)

.
(1) When the measured temperature is out of the range that is set by the upper/
lower limit value of the scaling range, the value set in the upper or lower limit
value of the scaling width is stored into the CH
Un\G57).
(2) Select "enable" for the scaling enable/disable setting (Un\G58).
When "disable" is selected, the settings of CH
limit value (Un\G62 to Un\G77) take no effect.
(3) For the channel for which the same value is set for the upper limit and the
lower limit, an error (error code 91 ) occurs. Then the error flag (XF) turns
ON and the operation is carried out with the setting before the error
occurrence.

scaling width upper/lower limit values (Un\G78 to Un\G93)

(1) When "disable" is selected for the scaling enable/disable setting (Un\G58),
the settings of CH
scaling width upper/lower limit value (Un\G78 to Un\G93)
take no effect.
(2) For the channel for which the same value is set for the upper limit and the
lower limit, an error (error code 91 ) occurs. Then the error flag (XF) turns
ON and the operation is carried out with the setting before the error
occurrence.
3.4.17 CH[] scaling range upper/lower limit values (Un\G62 to Un\G77)
scaling value (Un\G50 to
scaling range upper/lower
3.4 Buffer Memory
1
2
3
4
5
6
7
8
3
- 42

Advertisement

Table of Contents
loading

This manual is also suitable for:

Q68td-g-h01

Table of Contents