Advertisement
4. Installation Procedure
(1) Power off the GOT.
(2) Remove two extension unit covers of the GOT.
(3) Attach the extend interface relay board to the extend I/F-2 side on the
GOT.
After the installation, detach the connector cover from the extend
interface relay board.
(4) Fit the RGB output unit in the GOT case.
(5) Fasten the RGB output unit by tightening its mounting screws (4 places)
with tightening torgue 0.36 to 0.48 N•m.
(6) Fasten the bus connection unit by tightening the board fixing screws (2
places) with the tightening torque of 0.36 to 0.48 N•m.
5)
4)
6)
6
Remove the connector cover
3)
Advertisement
