Cleaning Anti-Reflective "Clear Vision" Coated Glass; Ceramic Fuel Effect Log Pieces And Convector Box Compartment Walls; Burner - Valor Inspire L Installer And Owner Manual

Hold the window panel base and lift upward until clear.
3. To remove the window door panel easier remove the visual baffle first.

Cleaning anti-reflective "Clear Vision" coated glass

Fingerprints are more visible on anti-reflective coated glass: it is advised to wear
(rubber) gloves when handling the panel. Coated "Clear Vision" glass panels can be
cleaned by using a non-abrasive glass cleaner and a soft cloth. Cleaner and cloth
used must not be scraping or abrasive. Use the cleaning products according to
instruction of use and only on cold surfaces. Particularly successful is a mixture of
distilled water and white spirits (at the ratio of 1:1). Abrasive cleaners (like glass
ceramic cleaners) or sharp-edged objects MUST NOT be used.
Clean the inside and the outside of the glass regularly. Ensure the glass is fully dried
before turning back on your gas fire.
NOTE: Regular cleaning of the glass is necessary to ensure the panel does not
become dull and difficult to clean.

Ceramic fuel effect log pieces and convector box compartment walls.

To gain access to the ceramic components the window door assembly must be
removed as in the previous Section 9 (1&2).
This product uses fuel effect pieces, burner compartment walls and ceramic
pebbles containing Refractory Ceramic Fibres (RCF), which are man-made
vitreous silicate fibres. Excessive exposure to this material may cause irritation
to eyes, skin and respiratory tract. Consequently, it is important to take care
when handling these articles to ensure that the release of dust is kept to a
minimum.
- Light coatings of soot will usually be burnt off during the normal operation of the fire.
Should any soot accumulation become excessive, the effected overlay log or ceramic
fuel effect base should be removed from the fire for cleaning.
- Cleaning should be carried out in a well ventilated area or in the open air by gently
brushing with the pieces held away from your face so that you avoid inhaling the dust.
- We do not recommend the use of a normal domestic vacuum cleaner which may
blow dust back into the air.
- We suggest that you remove the ceramic fuel effect kit pieces in the reverse order
to that shown in Section 15.
- Once cleaned replace the log fuel effect kit as in Section 15.

Burner.

To gain access to the burners the window assembly and the 3 large log ceramic
components must be removed as in the previous sections.
Remove any deposits of soot or other foreign matter from the surface of the burner
with a dry soft brush. Be careful not to brush any particles into the open slots.
Remove any particles from the slots with a vacuum cleaner fitted with a soft brush
attachment. Before using a vacuum cleaner remove all Pebbles/Chips and flakes.
Do not poke wire, etc. into the slots in the burner.
©
Page 53
GDC Group Ltd. SEPT 2018