Gas Supply Connection; Preparing Appliance For Installation - Valor Inspire L Installer And Owner Manual

INSTALLER GUIDE

8.GAS SUPPLY CONNECTION

The stove is designed for a rear connection only.
A nut and olive are provided for an 8mm pipe inlet connection to the 'T' connector at
the bottom front of the appliance. The 'T' connector can be rotated to allow
connection and includes a valve for isolating the gas supply and a pressure test point.
The supply pipe must be rigid material. Flexible pipe must not be used.

9. PREPARING APPLIANCE FOR INSTALLATION

1. Remove the glass door, by unscrewing by hand the single M5
knurled screw in an anti clockwise direction located just under the
base of the door frame in the middle. Keep these screw save as it
will be needed later. Carefully lift out at the base then up and away
from the convection box. Place carefully to one side.
2. Lift out carefully the Log set carton, carefully placing to one side
and the protective cardboard over the burner
tubes.
3. To lift up and out the fuel bed outer top tray
first unscrew the four screws as shown and
carefully place tray and screws to one side.
4. Detach the burner tray from the convection
box by removing four locating
screws. Slide the burner tray
forward and clear of the convection
box, taking care not to catch any of
the wires to the Ignition unit on the
LHS off the magnet for the Visual
baffle.
Place the screws and engine
assembly to one side carefully.
5. It is important that the inlet cover plate is fitted as
shown to cover the entry hole in the inside rear of the
convection box. The inlet cover plate has a slot to allow
the pipe to pass through its center. The slot is larger
than the 8mm pipe so the remaining open area should
be sealed with tape after the pipe is located.
© Page 19
GDC Group Ltd. SEPT 2018