3L - Paging Feature Built Into Remote Handset To Find Its Location; 3M - Advanced Setting Menu - Valor Inspire L Installer And Owner Manual

next symbol show a flashing sun symbol- press and release SET- as Mo is flashing
press and release SET again, enter the next time of 09:00- press and release SET-
change the flashing sun symbol to a flashing moon symbol by pressing and releasing
the + and – buttons then press and release SET again to store the moon setting
continue this until you have entered each time and temperature change required for
each day.
To put the fire into thermostat timer mode press and release the MODE button until
the thermostat and timer symbols are displayed on the display at the top. Press and
release the SET button and the control will now run the timed program set up in the
memory. To adjust any time setting in the memory re-enter the timer program setup
mode (by pressing SET and then MODE as described above). Then press set to
make the time flash. Now holding the + button advances the display to the next
setting and so on throughout the program. Amend the appropriate setting and when
finished do a long press of the SET button to exit the program mode.
To rest the whole timer program in the memory: - Hold handset- press set- press
mode until SETUP is flashing- press SET to enter SETUP- press SET about 8 times
until CP0 is flashing on the display use the + and – buttons to change the display to
CP1 – press SET – press SET again and the display will return to standby Manual
mode and the timer setting have been completely removed for the timer memory.

3l - Paging feature built into remote handset to find its location

If you have misplaced the handset (and it is in range of the fire), you can page it by
pressing the + button only on the fire control for around 5 seconds. The handset will
flash and make a noise to help you to locate it. Once you pick up the TESC it knows
you hold it and so the sound stops. The flashing and sound will last for 60 seconds
each time the handset is paged as described. If not found in 60 seconds, page again
and so on.
NOTE: PRESS "+" Button ONLY, NOT "+" and "- 'Together as you will accidentally
break the handset pairing and have to reset handset to factory state and pair again
(see other Page 25 of the booklet if this happens).
3m - Advanced settings Menu
In the event that you may wish to change the other pre-set settings of the control
features.
Do not do a long press and hold above but a normal short press and release will take
you into the advanced settings area.
Advanced settings options are: -
Back light –
A = Automatic (default setting). The back light comes on in the dark but not in
the light.
0 = Light never comes on.
1 = Light comes on whenever handset is unlocked.
Display contrast – 8 levels from 0 to 7 (default level 4).
©
GDC Group Ltd. SEPT 2018
Page 51