Burner Checks - Rc Model; Lighting The Fire; Adjusting Flame Height; Turning Off - Valor Inspire L Installer And Owner Manual

INSTALLER GUIDE

14.5 Burner checks - RC model

14.5.1 Lighting the fire.

-
If closed open the isolating 'T' connector valve.
,
Picking up and holding the handset firmly will unlock the
-
keypad and the green light will illuminate a solid green.
- Press and hold the 'ON' power button ( approx 1 - 2
seconds), then release as soon as the word "PILOT"
appears at the bottom left of the display this confirms the
start sequence has begun to ignite the three burners on
min setting.
NOTE: There is no "pilot only" setting on the RC model.

- 14.5.2 Adjusting flame height.

- To adjust the flame, hold the handset to enable the
buttons to work and press and hold the + button to
increase the flames accross all 3 burners together.
Tapping the button will adjust the flames step by step.
Holding the button will skip through the steps.
Similarly, press the - button to reduce the flame height.

14.5.3 Turning off.

- To turn off the fire, hold the handset to unlock the buttons
and then press the power button. The fire will turn off.
NOTE: Wait for the word 'OFF' to appear on the display
before trying to start again.
©
Page 28
GDC Group Ltd. SEPT 2018